Determination of Parameters of Grates on Rubber Brackets of Fiber Material Cleaners
J.V. Sai Prasanna Kumar
1Sharof Shukhratov – Assistant, Department of Safety of life activity, Fergana State University / Fergana, Uzbekistan.
2Ravshan Makhsudov – Doctor of technical sciences, Professor, Department of Safety of life activity, Fergana State University / Fergana, Uzbekistan.
3Anvar Djuraev – Doctor of Technical Sciences, Professor, Department of general technical disciplines, Tashkent Institute of Textile and Light Industry / Tashkent, Uzbekistan.
4Milašius Rimvydas – Doctor of technical sciences, Professor, Department of Production engineering, Kaunas University of Technology / Kaunas, Lithuania.
4Inom Yakubov – Assistant, Department of Safety of life activity, Fergana State University / Fergana, Uzbekistan.
Manuscript received on November 22, 2019. | Revised Manuscript received on December 15, 2019. | Manuscript published on December 30, 2019. | PP: 4263-4270 | Volume-9 Issue-2, December, 2019. | Retrieval Number: B3342129219/2019©BEIESP | DOI: 10.35940/ijeat.B3342.129219
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: The article shows the installation scheme of the grate and the principle of operation of the cleaner of fibrous material from large litter. The oscillation of the grates installed in the upper and lower cleaning zones with different thickness of the rubber support was studied. On the basis of theoretical studies of the grate in the form of a single-mass system, regularities of the change in vertical mixing and speeds of grates are obtained. Graphical dependences of the change in the amplitude of oscillations of the mixes and the speeds of the grate are constructed on the variation of the mass of the grate, the disturbing force on the cotton being revealed, and also on the stiffness coefficient of the elastic support. Full-factorial experiments obtained regression equations. By solving the problem, graphical dependencies of the change in the cleansing effect on incoming factors are constructed. The analyzes substantiate the parameters of the fibrous material cleaner.
Keywords: Fibrous material, cleaner, large litter, rubber support, thickness, vibration, stiffness, dissipation, full-factor, optimization.