Effect of Welding Parameters and Electrodes on Bead width using Gas Metal ARC Welding
Sanjeet Kumar1, Dipendra Kumar2
1Sanjeet Kumar (Assistant Professor) Mechanical Engineering Department Jaipur National University, Jaipur India.
2Dipendra Kumar (Associate Professor) Mechanical Engineering Department Jaipur National University Jaipur, India.
Manuscript received on October 01, 2019. | Revised Manuscript received on October 15, 2019. | Manuscript published on October 30, 2019. | PP: 1338-1343 | Volume-9 Issue-1, October 2019. | Retrieval Number: A1162109119/2019©BEIESP | DOI: 10.35940/ijeat.A1162.109119
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: In this research work, an attempt has been made to formulate and investigate the effect of GMAW conditions on bead width during the cladding of low carbon steel pale using AISI 308H electrodes. The Box- Behnken design has been employed for the development of mathematical relationship. The voltage, current and wire diameter have been considered as cladding conditions. The variation of bead width with voltage and current have been found non linear while, the effect of wire diameter on bead width has been observed linear. On the other hand, the bead width continuously increases with increase in voltage, current and wire diameter.
Keywords: Cladding; AISI 308H; low carbon steel; bead width; Box- Behnken design