PLC Based Multi-Product Vending Machine
D Sridhar Raja1, Abinethri. R2, T.Vijayan3
1Sridhar Raja D, Department of EIE, Bharath Institute of Higher Education and Research, (Tamil Nadu), India.
2R.Abinethri, Department of EIE, Bharath Institute of Higher Education and Research, (Tamil Nadu), India.
3T.Vijayan, Department of EIE, Bharath Institute of Higher Education and Research, (Tamil Nadu), India.
Manuscript received on 14 September 2019 | Revised Manuscript received on 23 September 2019 | Manuscript Published on 10 October 2019 | PP: 474-476 | Volume-8 Issue-6S2, August 2019 | Retrieval Number: F11340886S219/19©BEIESP | DOI: 10.35940/ijeat.F1134.0886S219
Open Access | Editorial and Publishing Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: The vending machine is a kind of cash driven machine that automatically distributes snacks, drinks and other consumer products automatically. Consumer pay coin into a slot, once a choice is made by pressing the push button, the machine dispenses the item purchased. Money, card or coin-based product vending machine by using embedded microcontrollers; Arduino and Raspberry Pi are currently used in systems. By using these microcontrollers, it is complicated when there was a technical error. In this project, we have created a multi-product coin type vending machine by using Mitsubishi PLC. The Programming Logic Controller (PLC) used automatically to monitor and control with high speed, efficiency, and reliability. Switch ON the power supply. Put the coin in the coin acceptor, and then select the product by pressing push button. The motor starts rotating along with the spring and moves the selected item until it released from the spring. The Hall Effect sensor used to count the rotation with the help of the magnet to sense. When the product released from the spring the motor stop rotating and the released product is ready to dispense. The drawback of the project is the vending machine cannot detect fake coins and the consumer cannot refund the money if they slot a coin when there is no product in the machine. [1],[ 3],[5].
Keywords: Hall Effect Sensor, DC Motor, Coin Acceptor, PLC(Programmable Logic Controller).
Scope of the Article: Machine Learning