Examination of Surface Finish in Burnishing of Brass and Copper
Kundan Kumar D1, B. Rajendra Prasad2, Vikash Kumar3, Eshwara Prasad Koorapati4
1Dr. Kundan Kumar D, Department of Mechanical Engineering, Malla Reddy College of Engineering, Maisammaguda, Dhulapally, Kompally, Secunderabad (Telangana), India.
2Mr. B. Rajendra Prasad, Department of Mechanical Engineering, Malla Reddy College of Engineering, Maisammaguda, Dhulapally, Kompally, Secunderabad (Telangana), India.
3Mr. Vikash Kumar, Department of Mechanical Engineering, Malla Reddy College of Engineering, Maisammaguda, Dhulapally, Kompally, Secunderabad (Telangana), India.
4Dr. Eshwara Prasad, Department of Mechanical Engineering, Malla Reddy College of Engineering, Maisammaguda, Dhulapally, Kompally, Secunderabad (Telangana), India.
Manuscript received on 01 November 2019 | Revised Manuscript received on 13 November 2019 | Manuscript Published on 22 November 2019 | PP: 1974-1977 | Volume-8 Issue-6S3 September 2019 | Retrieval Number: F13810986S319/19©BEIESP | DOI: 10.35940/ijeat.F1383.0986S319
Open Access | Editorial and Publishing Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: Fine machining process of cylindrical surfaces exposed to the high exploitation loadings has to ensure acceptable surface quality and it’s longer functionality. Quality of surface is an important factor to decide the performance of a manufactured product. The main aim of this research work is to analyse the impact of roller burnishing operation on the cylindrical work material, directed to achieving smaller roughness of test specimens. Roller burnishing is a fine machining process that is used to improve certain physical and mechanical properties. The common parameters in this work selected for burnishing process is to determine and analyse surface roughness. The process parameters considered for roller burnishing process are tool material, force applied and the number of tool passes. The Roller burnishing tool is made of high carbon steel, the burnishing operation is done on copper and brass specimens with different burnishing forces which are varying from 1 to 6 burnishing tool passes. The surface roughness of the specimens was measured before and after burnishing by using surface roughness tester. It has been observed from the surface roughness Ra.
Keywords: Roller Burnishing, Brass, Copper and Surface Finish.
Scope of the Article: Frequency Selective Surface