Single Polarized Microstrip Antenna Design for Mobile Communication Base Station
Okhaifoh, Joseph Ebosetale1, Oko-Oboh, Akhere Angus2, Umayah, Erhiega N.3
1Okhaifoh, Joseph Ebosetale, Dept. of Electrical and Electronic Engineering, Federal University of Petroleum Resources, Effurun, Delta State, Nigeria.
2Oko-oboh, Akhere Angus, National Agency for Science & Engineering Infrastructure (NASEN), Federal Ministry of Science and Technology, Abuja, Nigeria.
3Umayah, Erhiega N., Dept. of Electrical and Electronic Engineering, Federal University of Petroleum Resources, Effurun, Delta State, Nigeria.
Manuscript received on September 28, 2013. | Revised Manuscript received on October 11, 2013. | Manuscript published on October 30, 2013. | PP: 58-61 | Volume-3, Issue-1, October 2013. | Retrieval Number: F1996082613/2013©BEIESP
Open Access | Ethics and Policies | Cite
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: A single linear polarized antenna array element used in telecom base station is presented. It is of a considerable interest in broadband antenna element since it is simple to construct and also used as a low cost based station antenna designed for mobile communication system. In this paper, design and simulation was done through the use of 3D EM CST microwave studio and the results shows that high gain, low profile, wider bandwidth of operation, high isolation and low voltage standing wave ratio was achieved.
Keywords: Microstrip antenna, Mobile Communication, low profile, isolation, patch.