Exploratory Designing a Magnetic Induction Tomography Sensor Coil Circuit for Agarwood
Nurfarahin Ishak1, Chua King Lee2, Siti Zarina Mohd Muji3, Abdul Azlin Abdul Latip4
1Nurfarahin Ishak*, Faculty of Electrical and Electronics Engineering, Universiti Tun Hussein Onn Malaysia, Johor, Malaysia.
2Chua King Lee, Faculty of Electrical and Electronics Engineering, Universiti Tun Hussein Onn Malaysia, Johor, Malaysia.
3Siti Zarina Mohd Muji, Faculty of Electrical and Electronics Engineering, Universiti Tun Hussein Onn Malaysia, Johor, Malaysia.
4Abdul Azlin Bin Abdul Latip, Smart Modular Technologies (M) Sdn. Bhd, Pulau Pinang, Malaysia.
Manuscript received on January 18, 2021. | Revised Manuscript received on February 26, 2021. | Manuscript published on February 28, 2021. | PP: 163-168 | Volume-10 Issue-3, February 2021. | Retrieval Number: 100.1/ijeat.C21750210321 | DOI: 10.35940/ijeat.C2175.0210321
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: Magnetic induction tomography (MIT) is an imaging modality focused on tracing the transmission of electrical conductivity within the body. This technique used to image electromagnetic properties of an object by using the eddy current effect. This paper explains the primary analog transceiver circuit of MIT. This is a surrogate design of the analog system in the electronic components for pattern recognition and conditioning. This MIT system operating with a single excitation signal frequency at 10MHz. The input voltage received by the receiver sensor would become the circuit input which contained information. The four stages process in the receiver circuit successfully captured the signal from the transmitter. These subsystems have their functions and can be put into effect in many ways. Therefore, the circuit was used to be reliable at agarwood samples. The approach transceiver circuit were successful and functional for MIT coil sensing. The input voltage feedback depending on the conductivity of the samples. As the dielectric properties of samples are high, the input voltage at the receiver also high. Therefore, 10MHz can use for agriculture while this range of frequency is usually used in biomedical applications. Series – parallel circuit gives a greater induction factor and therefore more induced voltage for the load of the receiver.
Keywords: Magnetic induction tomography, excitation circuit, receiver circuit, coils
Scope of the Article: Nanometer-scale integrated circuits